Most South Jersey homeowners planning a new patio, front walk or garden path end up weighing the same two options: a poured concrete slab or interlocking concrete pavers. Both are made from cement and stone, and both can stand up to New Jersey weather when they are built and cared for properly. They fail in different ways, though, and our winters are very good at finding the weak spots in each.
This guide walks through how freeze-thaw cycles and de-icing salt affect each surface, what upkeep and repairs look like over the years, what actually drives the cost, and how to match the material to your yard. We pour concrete and build paver patios from our base in Woodbury Heights, NJ, so we have no reason to steer you toward one over the other.
The short answer
- Choose poured concrete if you want a smooth, continuous surface (broom-finished, or stamped and colored) and you are comfortable with two facts of life: it will crack at its control joints, which is by design, and patches rarely match the original.
- Choose pavers if you want patterns, color blends, borders or curves, or the option to lift and reset a section later without leaving a visible patch.
- Either way, the hidden parts matter most. An air-entrained 4,000 psi slab with correctly spaced joints, or pavers on a well-compacted base with solid edge restraints, will outlast a shortcut version of the other material.
Tip: The biggest winter threat to both surfaces is water that has nowhere to go. Before you pour or pave, make sure the new surface slopes away from the house and that downspouts do not empty onto it.
How New Jersey winters test a patio
NOAA describes New Jersey’s climate as moderately cold, occasionally snowy winters and warm, humid summers, with average January lows ranging from 15 to 20°F in the northwest to 25 to 30°F along the coast. That puts much of South Jersey right around the freezing mark on many winter nights, and the State Climatologist notes that snow can fall in the southern counties from about mid-November to mid-April. Each time water soaks into a surface, freezes, expands and thaws again, the surface takes a small hit.
What happens to poured concrete
The National Ready Mixed Concrete Association (NRMCA) calls the classic winter failure scaling: the finished surface flakes or peels, starting as small patches that can merge and spread. De-icing salt makes it worse by keeping the surface wetter and adding freeze-thaw cycles. According to NRMCA, most scaling comes down to a handful of causes:
- Concrete without entrained air (or too little of it), which leaves no room for freezing water to expand
- Low-strength concrete that lets water soak in
- Heavy de-icing salt on new concrete that is still saturated
- Finishing mistakes, such as overworking the surface or finishing while bleed water is still on top
- Poor curing, which leaves a weak surface layer
For exterior slabs that will see freezing and de-icing salt, NRMCA recommends ordering 4,000 psi concrete, consistent with the ACI 332 residential concrete code, air-entrained at about 6 percent total air for typical 3/4- to 1-inch stone, with a broom finish and proper curing.
Cracking is a separate issue. Concrete shrinks as it cures and dries, so control joints are cut to decide where it cracks. NRMCA calls joints “pre-planned cracks” and recommends spacing them at 24 to 36 times the slab thickness, about 10 feet for a 4-inch slab and no more than 15 feet, with panels close to square. Wire mesh does not prevent cracking; it only helps hold cracks tight. A crack running inside a joint is the slab doing its job. Random cracks across the middle of panels usually point to joint layout, base or drainage problems.
What happens to pavers
Concrete pavers are made in a plant under controlled conditions. The Concrete Masonry and Hardscapes Association (CMHA, now home to the former Interlocking Concrete Pavement Institute) explains that properly made pavers are dense, absorb little water and carry a high cement content, which is why they resist freeze-thaw damage. The product standard, ASTM C936, includes freeze-thaw and de-icing salt durability criteria.
A paver surface usually fails from below. The units sit on a thin bed of sand over a compacted aggregate base, held in place by edge restraints. If the base is too thin, poorly compacted or saturated, the surface settles, ruts or heaves. CMHA’s minimum base under ideal conditions is 4 inches for patios and walkways and 6 inches for residential driveways, and it advises a thicker base where soil is weak, drainage is poor or the ground freezes, which describes plenty of New Jersey yards. Its construction guide calls for about 1 inch of bedding sand, a base compacted to at least 98 percent of standard Proctor density, solid edge restraints and a slope of at least 1.5 percent.
De-icing salt: what is safe on concrete and pavers
The concrete and paver industries agree on the main points. Here is how their guidance lines up:
| Deicer or traction aid | Poured concrete (NRMCA) | Concrete pavers (CMHA) |
|---|---|---|
| Rock salt (sodium chloride) | Acceptable in moderate amounts after the first winter | Least damaging option; use whenever possible |
| Calcium chloride | Acceptable in moderate amounts after the first winter | Use judiciously when you need faster melting |
| Magnesium chloride and other magnesium-based products | Never use as a deicer | Not recommended; CMHA also advises against calcium magnesium acetate |
| Ammonium sulfate or ammonium nitrate | Never use as a deicer | Not addressed in the CMHA guidance |
| Sand for traction | Recommended in place of salt during the first winter | Not recommended on permeable pavers, where it reduces drainage through the joints |
A few habits protect both surfaces and your local water supply:
- Shovel first. New Jersey American Water points out that clearing snow before it turns to ice reduces how much de-icer you need, and CMHA warns against using salt in place of snow removal.
- Use less than you think. The utility notes that a 12-ounce coffee mug holds about a pound of salt, enough to treat a 20-foot driveway, with granules scattered a few inches apart.
- Clean up. Sweep leftover salt off dry pavement so it does not wash into storm drains, and, per NRMCA, hose off salt that cars track onto driveways and garage slabs when the weather allows.
- Keep new concrete salt-free its first winter. NRMCA advises avoiding de-icing chemicals on newly placed concrete and using clean sand instead.
- Fix ponding. NRMCA notes that poor drainage, which lets salty water sit on concrete, increases the severity of the exposure.
Good to know: Ice melts are sold under many labels, and some blends contain magnesium chloride. Both NRMCA and CMHA advise against magnesium-based deicers on concrete surfaces, so read the ingredient list, not just the claims on the front of the bag.
Concrete vs. pavers at a glance
| Factor | Poured concrete | Concrete pavers |
|---|---|---|
| How it is built | Air-entrained concrete placed over a compacted base, then finished, jointed and cured on site | Factory-made units set on about 1 inch of bedding sand over a compacted aggregate base, locked in by edge restraints |
| Freeze-thaw risk | Surface scaling if the mix, finishing or curing is off, or with heavy early salting | Units are dense and tested for freeze-thaw; most problems start in the base, drainage or edges |
| Cracking | Expected at control joints; random cracks signal joint, base or drainage issues | Joints between units absorb small movements; a cracked unit can be swapped out |
| Settling or heaving | A whole section can sink or lift as one piece | Low spots and ruts can be lifted and re-leveled |
| Repairs | Patches and resurfacing rarely match the original color or texture | The same units can be reinstated with no visible patch |
| Salt tolerance | Rock salt or calcium chloride in moderation after the first winter; no magnesium or ammonium products | Rock salt preferred; calcium chloride sparingly; no magnesium products |
| Routine upkeep | Periodic breathable sealer; keep joints and the edge along the house sealed | Top up joint sand, pull weeds, re-level settled spots; sealer optional |
| Looks | Broom finish, or stamped and colored patterns | Many shapes, colors and laying patterns, plus borders and curves |
| Install timing | Weather-sensitive pour and cure | Units arrive fully cured; can go down in cool weather as long as the base and sand are not frozen |
Upkeep and repairs over the years
Caring for poured concrete
- Seal it. NRMCA recommends a breathable silane or siloxane sealer made for concrete slabs, applied when the concrete is reasonably dry. Late summer, after a few dry days, is the ideal window.
- Keep water moving. Redirect downspouts and fix low spots so meltwater does not pond and refreeze on the slab.
- Salt smart. Sand only during the first winter, then moderate amounts of rock salt or calcium chloride.
- Know the limits of patching. NRMCA notes that light to moderate scaling can be resurfaced with a thin bonded overlay, but the repair will not match the color and character of the original concrete. Severe or spreading scaling usually means replacing the affected panels.
Caring for pavers
- Top up joint sand. Sand in the joints is what locks units together, so replace what washes out. CMHA notes that joint sand stabilizers and sealers can improve performance but are not essential.
- Pull weeds early. Small weeds in joints come out easily; established roots push units apart.
- Re-level instead of replacing. CMHA’s maintenance guide explains that sunken or disturbed areas can be taken up and the same units reinstated, with no jackhammering, no visible patch and no curing time.
- Keep spares. CMHA suggests stockpiling extra pavers from the original job for future repairs, scattering them through the pattern to blend color differences.
- Watch the edges. A failing edge restraint lets units creep apart and opens joints.
What drives the cost (without the price tags)
We do not publish prices, because two patios of the same size can be very different jobs. These are the factors that move the number for either material:
- Size, shape and levels. Curves, steps, seat walls and multiple levels add forming or cutting time.
- Tear-out and excavation. Removing an old slab, sod, roots or debris, and hauling it away.
- Base depth. Set by your soil and the use: a patio, a walkway that gets shoveled and salted, or a driveway.
- Drainage work. Regrading, relocating downspouts or adding a channel drain so water stays off the new surface.
- Finish and product. Plain broom finish versus stamped and colored concrete; paver style, color blend, laying pattern and borders.
- Access. Whether a concrete truck can reach the pour, or whether material has to be pumped or wheeled into a tight backyard.
- Long-term upkeep. Sealing, joint sand, salt habits and how easily repairs can be made over the years.
Every estimate we give is free, and you can ask about 0% financing options.
Which one fits your project?
Use this checklist to narrow it down before your estimate:
- Back patio for furniture and grilling: Either works. Concrete gives a smooth, simple surface; pavers suit curves and patterns and make it easier to add features later.
- Front walkway and steps: These get the most shoveling and salt, so follow the salt rules above. Concrete steps and walks are a common pairing; pavers suit curved paths.
- Near large trees: Roots can lift either surface over time, but pavers can be taken up and reset around them.
- Low or wet areas: Fix the drainage first. Neither material tolerates a saturated base through a New Jersey winter.
- Driveways: A driveway carries far heavier loads, so base depth and thickness matter even more. CMHA’s minimum paver base rises from 4 inches for a patio to 6 inches for a residential driveway, even under ideal conditions.
- Stamped concrete: A middle path that gives a patterned look in one slab, with the same joint, sealing and repair trade-offs as plain concrete.
- Zoning: Before adding any new patio or walkway, check your township’s zoning rules, such as setbacks and limits on lot or impervious coverage. Rules vary by municipality, and this guide is general information, not legal advice.
When to call a pro
Call for an assessment when you notice any of these:
- Random cracks crossing the middle of concrete panels, or cracks that widen each winter
- Scaling that spreads a little more every spring
- A slab or stoop that has sunk or tilted toward the house
- Pavers that are sinking, rutting or spreading apart at the edges
- Water or ice that collects in the same spot every storm
If you are leaning toward concrete, see our concrete patio, steps and walkway and concrete driveway pages, or the full concrete services overview. If pavers are the better fit, start with paver patios and hardscaping and our wider landscaping services. Water problems around the house come first, and our downspout and sump drainage work keeps meltwater off new surfaces. If you plan to pour, read our guide to the best time to pour concrete in New Jersey, and check the towns we serve across South Jersey.
Not sure which surface suits your yard? Request a free estimate, and we can look at the soil, slope and drainage with you and talk through both options for your space. Every project is backed by our 1-Year Workmanship Warranty, a limited warranty covering labor and materials to correct defects in our workmanship and in the materials we install; the full written terms come with your estimate and contract. Ask about 0% financing options when you call or request your estimate below.
